Introduction

Replace the LCD in your HP Pavilion dv6000.

  1. Remove rubber screw covers from the LCD screen. The top covers pop off with a fingernail but the two on the bottom may require a screwdriver or flat tool.
    • Remove rubber screw covers from the LCD screen. The top covers pop off with a fingernail but the two on the bottom may require a screwdriver or flat tool.

    • Remove the six 7.15mm screws underneath the stoppers. There are four on top and two on bottom.

    Ajouter un commentaire

  2. Press the tabs on the sides of the screen in and pop the plastic off. Careful, the plastic is very flimsy and may break.
    • Press the tabs on the sides of the screen in and pop the plastic off. Careful, the plastic is very flimsy and may break.

    Ajouter un commentaire

    • Remove the two screws (5.8mm) on either side of the LCD near the hinge. Remove the screws on the outermost side first.

    Ajouter un commentaire

    • Take out the two 3.58mm screws on the LCD at the top (one on each edge).

    Ajouter un commentaire

    • Hold on to the LCD screen to prevent it from falling over and remove the two 3.58mm screws on the sides at the bottom.

    Ajouter un commentaire

    • Let the screen gently rest on the keyboard.

    • Remove the tape from the ribbon.

    • Stop here and check the cable

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

13 autre(s) ont terminé cette réparation.

Ben Hirsch

Membre depuis le 05/10/2010

3 622 Réputation

10 tutoriels rédigés

Équipe

Cal Poly, Team 21-33, Regan Fall 2010 Membre de l'équipe Cal Poly, Team 21-33, Regan Fall 2010

CPSU-REGAN-F10S21G33

4 membres

10 tutoriels rédigés

after replacing my cracked screen the back light does not show again

firelionkofi - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 20

30 derniers jours : 81

Total : 36,391