Introduction

Replace the wireless card in your HP Pavilion dv6000.

Lay the laptop on a flat surface, battery side up.
  • Lay the laptop on a flat surface, battery side up.

  • Remove the two screws securing the RAM shield to the lower case.

  • The screws will remain captive within the shield.

  • Lift and remove the RAM shield up from the lower case.

Ajouter un commentaire

Use a pair of tweezers to disconnect both antennas from their sockets on the wireless card.
  • Use a pair of tweezers to disconnect both antennas from their sockets on the wireless card.

  • Be careful to pull on the contacts and not the wires. The crimps used to hold them to the wires are delicate.

Ajouter un commentaire

  • Remove the two 3.7 mm Phillips screws securing the wireless card to the motherboard.

  • Upon removing the Phillips screws that secures the wireless card to the motherboard, the wireless card board should pop up from its top side.

  • Grasp the wireless card and pull it straight out of its socket on the motherboard.

Ajouter un commentaire

  • Wireless card remains.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

4 autre(s) ont terminé cette réparation.

Ben Hirsch

Membre depuis le 05/10/2010

3 607 Réputation

10 tutoriels rédigés

Équipe

Cal Poly, Team 21-33, Regan Fall 2010 Membre de l'équipe Cal Poly, Team 21-33, Regan Fall 2010

CPSU-REGAN-F10S21G33

4 membres

10 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 6

7 derniers jours : 20

30 derniers jours : 74

Total : 24,889