Introduction

A replacement guide for the motherboard of the HP Pavilion dv7t-7000

Turn the computer off and disconnect if from all power sources.
  • Turn the computer off and disconnect if from all power sources.

Ajouter un commentaire

Slide the battery release switch to the left.
  • Slide the battery release switch to the left.

Ajouter un commentaire

  • Hold the release switch all of the way to the left and your other hand to pull the battery out.

Ajouter un commentaire

  • Unscrew the single Phillips #00 screw.

  • Screw will not come out, it is connected to the panel

Ajouter un commentaire

  • Remove service hatch by sliding away from the computer and lifting up.

Ajouter un commentaire

  • Remove the single Phillips #00 screw.

  • Flip the laptop over.

Ajouter un commentaire

  • Wedge a spudger in between the keyboard and palm rest bezel.

  • Pry upward to release the keyboard clips.

  • The keyboard is plugged into the motherboard, so be careful not to pull out while lifting keyboard.

Ajouter un commentaire

  • Use the flat end of a spudger to flip up the black tab on the ZIF connectors.

  • Pull the ribbon cables out of the ZIF connectors.

  • Remove the keyboard.

Ajouter un commentaire

  • Push the retraining springs away from the RAM at the same time to unlock the RAM.

Ajouter un commentaire

  • Pull the RAM out.

  • Follow the same procedure for the additional RAM.

Ajouter un commentaire

  • Use the flat end of a spudger to pop off the antenna connectors.

Ajouter un commentaire

  • Remove single Phillips #00 screw.

  • Pull the card out by hand.

Ajouter un commentaire

  • Flip the keyboard back over.

  • Remove the single Phillips #00 screw holding in the CD drive.

  • Pull out the CD drive.

Ajouter un commentaire

  • Remove the seventeen Phillips #00 screws securing the back panel to the laptop.

Ajouter un commentaire

  • Flip the laptop over.

  • Remove the single Phillips #00 screw.

Ajouter un commentaire

  • Remove the panel by lifting it up.

Ajouter un commentaire

  • Remove the eleven Phillips #00 screws.

Ajouter un commentaire

  • Use the flat end of a spudger to disconnect all wires connected to the motherboard.

Ajouter un commentaire

  • Lift up the black tab on the ZIF connector with the flat end of a spudger.

  • Pull the ribbon cable out of the ZIF connector.

  • Remove the fan from the laptop.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

emmanuella Dickson-itua

Membre depuis le 21/02/2018

97 Réputation

1 tutoriel rédigé

Équipe

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 15

Total : 75