The large back panel contains a lot of screws that help keep it in tact. It covers and protects the majority of your device's insides. It can be somewhat tricky to remove.


Aucune pièce nécessaire.

Slide pill shaped tab to the other side of the channel.
  • Slide pill shaped tab to the other side of the channel.

Ajouter un commentaire

  • Remove battery while keeping the tab to the side.

Ajouter un commentaire

  • Unscrew the two screws JIS #0 located on opposites sides of the panel.

  • Screws are attached to the panel and will not fully come out.

Ajouter un commentaire

  • Carefully pry off the L-shaped panel.

Ajouter un commentaire

  • Unscrew all nine 6.0mm JIS #0 screws located on the border of the back panel.

Ajouter un commentaire

  • Remove 3 screws located where the battery previously was.

Ajouter un commentaire

  • Remove 6 screws located under the spot where the smaller L-shaped panel was located.

Ajouter un commentaire

  • Slowly pry off the keyboard from the back panel.

  • Between the back panel and the keyboard there are two ribbon wires.

  • Remove slowly to not break the back panel. If it does not come off easily, check to see if all screws are removed.

Ajouter un commentaire

  • Unplug wires connecting back panel to keyboard.

Ajouter un commentaire


To reassemble your device, follow these instructions in reverse order.

Robert Hamilton

Membre depuis le 01/03/2018

1 051 Réputation

10 tutoriels rédigés


UMass Dartmouth, Team S2-G7, Simcock Spring 2018 Membre de l'équipe UMass Dartmouth, Team S2-G7, Simcock Spring 2018


4 membres

10 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 5

Total : 51