Introduction

The speakers are relatively easy to remove. There are no screws. All you need to do is disconnect a wire and pull.

Slide pill shaped tab to the other side of the channel.
  • Slide pill shaped tab to the other side of the channel.

Ajouter un commentaire

  • Remove battery while keeping the tab to the side.

Ajouter un commentaire

  • Unscrew the two screws JIS #0 located on opposites sides of the panel.

  • Screws are attached to the panel and will not fully come out.

Ajouter un commentaire

  • Carefully pry off the L-shaped panel.

Ajouter un commentaire

  • Pull out and unplug the tab on the right hand side.

Ajouter un commentaire

  • Unscrew all nine 6.0mm JIS #0 screws located on the border of the back panel.

Ajouter un commentaire

  • Remove 3 screws located where the battery previously was.

Ajouter un commentaire

  • Remove 6 screws located under the spot where the smaller L-shaped panel was located.

Ajouter un commentaire

  • Slowly pry off the keyboard from the back panel.

  • Between the back panel and the keyboard there are two ribbon wires.

  • Remove slowly to not break the back panel. If it does not come off easily, check to see if all screws are removed.

Ajouter un commentaire

  • Unplug wires connecting back panel to keyboard.

Ajouter un commentaire

  • Unplug the red and white wires.

Ajouter un commentaire

  • Remove the speakers.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Robert Hamilton

Membre depuis le 01/03/2018

1 051 Réputation

10 tutoriels rédigés

Équipe

UMass Dartmouth, Team S2-G7, Simcock Spring 2018 Membre de l'équipe UMass Dartmouth, Team S2-G7, Simcock Spring 2018

UMASSD-SIMCOCK-S18S2G7

4 membres

10 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 7

Total : 37