Introduction

Did your hard drive crash? Or are you looking for more speed or capacity from a new hard drive? This guide will walk you through replacing your hard drive

Pièces

Aucune pièce nécessaire.

Unscrew one Phillips #1 screw from the back panel.
  • Unscrew one Phillips #1 screw from the back panel.

  • The screw is on a spring and attached to the panel. It will pop up, but will not separate from the back panel.

Ajouter un commentaire

Slide the back panel down and pull it up.
  • Slide the back panel down and pull it up.

Ajouter un commentaire

  • Static electricity can damage the components of your laptop. Make sure you are wearing an anti-static bracelet before you touch the hard drive.

  • Using the black tab on the connect and/or a prying tool, lift up to disconnect the black hard drive cable from the green circuit board.

  • Pull the black cable up and out of the back panel. This will make taking the hard drive out much easier.

Ajouter un commentaire

  • Gently pull up on the plastic tab attached to the hard drive.

  • Pull the hard drive up and to the right to remove it completely from the laptop.

Ajouter un commentaire

  • Remove the black SATA cable from the hard drive.

Ajouter un commentaire

  • Remove the black rubber end caps.

Ajouter un commentaire

  • Remove the four silver 5 mm Phillips #1 screws from the hard drive.

Ajouter un commentaire

  • Remove the plastic cover from the hard drive.

Ajouter un commentaire

Conclusion

To reassemble or replace your hard drive, follow these instructions in reverse order with the working drive.

2 autre(s) ont terminé cette réparation.

Erik Miller

Membre depuis le 22/04/2014

1 665 Réputation

4 tutoriels rédigés

Équipe

Cal Poly, Team 11-51, Amido Spring 2014 Membre de l'équipe Cal Poly, Team 11-51, Amido Spring 2014

CPSU-AMIDO-S14S11G51

4 membres

12 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 7

30 derniers jours : 37

Total : 2,998