Introduction

Replace the TouchSmart display screen on the front of the printer. This screen serves as the main menu and control of all the machine's functions. If the screen becomes unresponsive or physically damaged, it may need to be replaced.

Pièces

Aucune pièce nécessaire.

Open the top of printer. The printer should appear as shown.
  • Open the top of printer. The printer should appear as shown.

Ajouter un commentaire

Use the blue plastic opening tool to pry the trim pieces all the way around the printer.
  • Use the blue plastic opening tool to pry the trim pieces all the way around the printer.

  • Loosen the pieces around the edges before pulling to remove from the printer.

  • Pull the (4) trim pieces off and set them aside.

Ajouter un commentaire

  • Using the blue plastic opening tool, pull from the middle and then slide back to remove the side panels.

  • The side trim pieces need to be removed before the front trim pieces.

Ajouter un commentaire

  • Using the T9 Torx Security screwdriver bit, unscrew the five 12mm screws shown.

Ajouter un commentaire

  • The scanner flap is attached by a clip that can be dislodged by pulling it gently away from the printer.

  • Keeping the scanner flap upright, slide it toward the unattached clip in order to dislodge the second clip.

  • Both clips will come unattached and you can set the scanner flap aside.

Ajouter un commentaire

  • Lift the scanner glass piece from the printer and set it aside.

Ajouter un commentaire

  • Gently pull the display screen away from the printer.

  • Locate & unscrew the two 12mm screws using the T9 Torx Security screwdriver bit.

Ajouter un commentaire

  • Place thumb and forefinger where shown and pull this piece away from the printer.

  • Do not pull it away too hard. The piece is still connected by wiring ribbon.

Ajouter un commentaire

  • Pull both wiring ribbons out from the display screen piece. This will separate the piece from the printer.

  • Use tweezers if necessary.

Ajouter un commentaire

  • Push forward and down to release the retaining piece. This will detach the display screen from the front panel.

Ajouter un commentaire

  • Set the display screen face down.

  • Locate and unscrew all four 12mm screws on the back on the display screen using the T9 Torx Security screwdriver bit.

Ajouter un commentaire

  • Lift the back of the display screen to remove it.

Ajouter un commentaire

  • Place hands as shown and push with your thumbs to detach the plastic from the screen.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Laura

Membre depuis le 23/10/2014

628 Réputation

3 tutoriels rédigés

Équipe

Michigan Tech, Team 1-2, Lauer Fall 2014 Membre de l'équipe Michigan Tech, Team 1-2, Lauer Fall 2014

MTU-LAUER-F14S1G2

3 membres

5 tutoriels rédigés

where can i get replacement part

fernando - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 13

Total : 696