Pièces

Aucune pièce nécessaire.

  1. Before disassembling your printer, be sure that the printer has been unplugged.
    • Before disassembling your printer, be sure that the printer has been unplugged.

    • Rotate the printer 90 degrees counter clockwise so that the side panel next to control panel is facing you.

    • Remove the two T10 12mm Torx screws from the left side panel.

    Ajouter un commentaire

  2. Firmly pull the the back of the side panel until it separates from the body of the printer.
    • Firmly pull the the back of the side panel until it separates from the body of the printer.

    • Rotate the side panel upwards while pulling it towards yourself to remove the panel.

    Ajouter un commentaire

    • Rotate the printer 90 degrees clockwise.

    • Grasp the paper tray and rotate it down.

    • Insert your fingers into the slot in the printer door and pull to rotate the gate down.

    Ajouter un commentaire

    • Rotate the printer 90 degrees clockwise.

    • Remove the two T10 12 mm Torx screws.

    • Grasp both sides of the side panel and pull it forward to remove the panel.

    Ajouter un commentaire

    • Rotate the printer 90 degrees counter clockwise.

    • Lift the scanner lid to expose the scanner glass.

    Ajouter un commentaire

    • Remove the two T10 12 mm Torx screws.

    • Do not attempt to lift the top panel off the printer yet because it is still connected to the printer body by a cable.

    Ajouter un commentaire

    • Rotate the printer 90 degrees counter clockwise.

    • Inside the printer is a small white tab. Press it inward with a spudger until a pop is heard.

    • Remove the front panel by grasping its front and pulling away from the printer.

    Ajouter un commentaire

    • Rotate the printer 90 degrees clockwise.

    • Remove the cable connecting the top panel of the printer to the power button assembly.

    Ajouter un commentaire

    • Carefully lift the top panel of the printer away from the printer body.

    Ajouter un commentaire

    • Set aside the printer body.

    • Remove the three T10 12 mm Torx screws from the back of control panel circuit board.

    Ajouter un commentaire

    • Using both hands, carefully lift the control panel circuit board from the top panel of the printer.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Jim

Membre depuis le 06/10/2011

915 Réputation

10 tutoriels rédigés

Équipe

Cal Poly, Team 20-30, Maness Fall 2011 Membre de l'équipe Cal Poly, Team 20-30, Maness Fall 2011

CPSU-MANESS-F11S20G30

4 membres

10 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 1

30 derniers jours : 12

Total : 3,754