Ce tutoriel a des changements plus récents. Passer à la dernière version non vérifiée.
Ce dont vous avez besoin
-
-
Rotate the printer 90 degrees counter clockwise so that the side panel next to control panel is facing you.
-
Remove the two T10 12mm Torx screws from the left side panel.
-
-
-
-
Set aside the printer body.
-
Remove the three T10 12 mm Torx screws from the back of control panel circuit board.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
4 autres ont terminé cette réparation.