Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Unplug the device from any energy sources.
-
Lift the top cover of the scanner.
-
Use a plastic opening tool to remove the plastic frame surrounding the glass.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use a T10 screwdriver to unscrew the two screws that fasten the frame to the printer hood.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Put your finger behind the panel with the power button.
-
Then, pull the piece outwards.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Unscrew the screw inside the power button panel space.
-
Then, unscrew the screw that is across the printer slider.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Pull the white circuit board outwards which is located under the small screen.
-
Unplug the small ribbon cable from the circuit board.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Unplug the small ribbon cable from the circuit board. Be careful when you unplug the ribbon cable not to use too much force. Using too much force may damage or rip the cable.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Pull the memory card reader's circuit board out.
-
Detach the white wiring connector from the back of the circuit board.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Put your finger behind the small screen.
-
Then, pull it up.
-
Disconnect the ribbon cable from the small screen.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
With the top half of the printer separated, lift the upper section with the scanner glass away from the lower section of the printer.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
With the glass facing upwards, remove the screw holding the glass in place.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Lift the glass up and away from the printer.
-
Replace the broken glass piece with the replacement glass
-
Annulation : je n'ai pas terminé ce tutoriel.
2 autres ont terminé cette réparation.