Aller au contenu principal

Introduction

In this repair guide you will be replacing the daughterboard in the HTC Desire 610. After doing this replacement, you will fix the micro USB port and also be able to successfully charge your phone again.

  1. Open the SD card slot.
    • Open the SD card slot.

  2. Using plastic opening tool, take off the back cover of the phone. Using plastic opening tool, take off the back cover of the phone. Using plastic opening tool, take off the back cover of the phone.
    • Using plastic opening tool, take off the back cover of the phone.

  3. Using Phillips #000 Screwdriver, remove the two 2.5mm phillips head screws.
    • Using Phillips #000 Screwdriver, remove the two 2.5mm phillips head screws.

  4. Using Torx T5 Screwdriver, remove the four 5mm silver torx head screws.
    • Using Torx T5 Screwdriver, remove the four 5mm silver torx head screws.

  5. Fix Kits pour iPhone X

    Finie la garantie ? Pas de soucis, nous avons de quoi réparer.

    Acheter maintenant

    Fix Kits pour iPhone X

    Finie la garantie ? Pas de soucis, nous avons de quoi réparer.

    Acheter maintenant
  6. Using Torx T5 Screwdriver, remove the four 4mm black torx screws
    • Using Torx T5 Screwdriver, remove the four 4mm black torx screws

  7. Using plastic opening tool, remove the black plastic circuit cover. Using plastic opening tool, remove the black plastic circuit cover.
    • Using plastic opening tool, remove the black plastic circuit cover.

  8. Using Torx T5 Screwdriver, remove the 4mm black torx screw.
    • Using Torx T5 Screwdriver, remove the 4mm black torx screw.

  9. Using Tweezers, disconnect antenna wire. Using Tweezers, disconnect antenna wire.
    • Using Tweezers, disconnect antenna wire.

  10. Using Tweezers, remove loud speaker that is being held by small adhesive. When putting loud speaker back on, the prongs sticking up should be on the side closer to the top of the phone. When putting loud speaker back on, the prongs sticking up should be on the side closer to the top of the phone.
    • Using Tweezers, remove loud speaker that is being held by small adhesive.

    • When putting loud speaker back on, the prongs sticking up should be on the side closer to the top of the phone.

  11. Using Tweezers, peel back gray adhesive. Using Tweezers, peel back gray adhesive.
    • Using Tweezers, peel back gray adhesive.

  12. Using Tweezers, flip the white strip upward so it sits 90°. Using Tweezers, flip the white strip upward so it sits 90°.
    • Using Tweezers, flip the white strip upward so it sits 90°.

  13. Using plastic opening tool, pry up green plate and pull outward. Daughterboard is off. Get new daughterboard and reverse steps. Daughterboard is off. Get new daughterboard and reverse steps.
    • Using plastic opening tool, pry up green plate and pull outward.

    • Daughterboard is off. Get new daughterboard and reverse steps.

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Austin Phelps

Membre depuis le 31/01/2016

194 Réputation

1 tutoriel rédigé

Équipe

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 5

Total : 1,472