Introduction

Is your Droid Incredible not sounding so incredible? Use this guide to replace the rear speaker.

Press your thumbnail into the slot between the rear panel and the front case located in the bottom of the phone. Useful tip: a penny or dime works in a pinch if you can't use your thumbnail. Gently pry the rear panel up and away from the phone. You may need to slide your thumb up the crack to separate the rear panel from the front case.
  • Press your thumbnail into the slot between the rear panel and the front case located in the bottom of the phone.

    • Useful tip: a penny or dime works in a pinch if you can't use your thumbnail.

  • Gently pry the rear panel up and away from the phone. You may need to slide your thumb up the crack to separate the rear panel from the front case.

Ajouter un commentaire

Remove the rear panel from the phone.
  • Remove the rear panel from the phone.

Ajouter un commentaire

Insert a fingertip into the gap between the battery and the rear inner frame, located between the battery and the speaker. Slide the battery away from the speaker, widening the gap. Lift the top of the battery up and remove the battery from the rear inner frame. Lift the top of the battery up and remove the battery from the rear inner frame.
  • Insert a fingertip into the gap between the battery and the rear inner frame, located between the battery and the speaker. Slide the battery away from the speaker, widening the gap.

  • Lift the top of the battery up and remove the battery from the rear inner frame.

Ajouter un commentaire

Press the MicroSD card further into its slot until it clicks. Release the MicroSD card, and it will pop out slightly.
  • Press the MicroSD card further into its slot until it clicks.

  • Release the MicroSD card, and it will pop out slightly.

Ajouter un commentaire

Pull the MicroSD card straight out of its slot. Pull the MicroSD card straight out of its slot.
  • Pull the MicroSD card straight out of its slot.

Ajouter un commentaire

Remove four T6 Torx screws securing the rear inner frame to the front case.
  • Remove four T6 Torx screws securing the rear inner frame to the front case.

Ajouter un commentaire

The rear inner frame is attached to the front case by nine plastic clips, marked here for reference.
  • The rear inner frame is attached to the front case by nine plastic clips, marked here for reference.

Ajouter un commentaire

Starting on the bottom of the phone, gently push in on the (red) rear inner frame behind each black clip with a small flathead screwdriver. Go slow and be gentle, you may have to go back and forth between each side several times to work the rear inner case free.
  • Starting on the bottom of the phone, gently push in on the (red) rear inner frame behind each black clip with a small flathead screwdriver.

  • Go slow and be gentle, you may have to go back and forth between each side several times to work the rear inner case free.

Ajouter un commentaire

Loosen the clips on the side next to the camera using the method described in the previous step. Loosen the clips on the side next to the camera using the method described in the previous step.
  • Loosen the clips on the side next to the camera using the method described in the previous step.

Ajouter un commentaire

Rotate the phone 180 degrees and loosen the three clips on the side by the speaker. Note that the middle clip on this side is smaller than the others. Rotate the phone 180 degrees and loosen the three clips on the side by the speaker. Note that the middle clip on this side is smaller than the others.
  • Rotate the phone 180 degrees and loosen the three clips on the side by the speaker. Note that the middle clip on this side is smaller than the others.

Ajouter un commentaire

Use the same technique to loosen the clip on the top of the phone. You may need to gently lift the bottom of the rear inner frame to free this clip. You may need to gently lift the bottom of the rear inner frame to free this clip.
  • Use the same technique to loosen the clip on the top of the phone.

  • You may need to gently lift the bottom of the rear inner frame to free this clip.

Ajouter un commentaire

Remove the rear inner frame. Remove the rear inner frame.
  • Remove the rear inner frame.

Ajouter un commentaire

Pry the rear speaker out of its socket with a small flathead screwdriver. Pry the rear speaker out of its socket with a small flathead screwdriver.
  • Pry the rear speaker out of its socket with a small flathead screwdriver.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order. Note that the spring contacts on the rear speaker must face toward the outside of the device, to connect with the logic board.

Andrew Optimus Goldberg

Membre depuis le 17/10/2009

379 263 Réputation

1 306 tutoriels rédigés

Équipe

iFixit Membre de l'équipe iFixit

Community

109 membres

6 189 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 3

30 derniers jours : 3

Total : 1,076