Aller au contenu principal

Introduction

HTC One X is also known as S720E.

How to disassemble the phone and change the LCD Display & Touchscreen / Digitizer (the complete spare part).


Please SUBSCRIBE to my channel ツ

Vidéo d'introduction

  1. Switch-off the phone (if you can). Remove the SIM tray. The back cover is sticked to the phone with adhesive tape. Is good to use some hot air to do removing of the back cover easier.
    • Switch-off the phone (if you can).

    • Remove the SIM tray.

    • The back cover is sticked to the phone with adhesive tape. Is good to use some hot air to do removing of the back cover easier.

  2. Start opening from the bottom side. For separating the back cover, use only plastic tools. For separating the back cover, use only plastic tools.
    • Start opening from the bottom side.

    • For separating the back cover, use only plastic tools.

  3. The mother board is held by 6x Philips screws. The mother board is held by 6x Philips screws. The mother board is held by 6x Philips screws.
    • The mother board is held by 6x Philips screws.

  4. Batteries pour ordinateurs portables

    Une réparation facile pour un gain en puissance max.

    Acheter maintenant

    Batteries pour ordinateurs portables

    Une réparation facile pour un gain en puissance max.

    Acheter maintenant
  5. Disconnect one by one: the Touchscreen flex cable the Volume buttons & Mic flex cable
    • Disconnect one by one:

    • the Touchscreen flex cable

    • the Volume buttons & Mic flex cable

    • the Dock connector flex cable

    • Use a plastic tool to unstick the battery.

    • Be careful, there are flex cables under the battery. At the last picture in this step you can see the cables and the place were is adhesive tape.

    • Now you can separate the Dock flex cable.

  6. Lift the motherboard slightly to disconnect two flex cables: the LCD Display flex cable the Navigation buttons flex cable
    • Lift the motherboard slightly to disconnect two flex cables:

    • the LCD Display flex cable

    • the Navigation buttons flex cable

    • Disconnect the Power On button flex cable at the upper side of the phone

    • Now the mainboard and the battery are free.

    • Disconnect the battery from the mainboard.

  7. At the beginning you can use a cutter to make a room for the plastic tool. During the procedure of the separating the LCD Display & Touchscreen from the frame, you can use again hot air. This will make separating more easy. During the procedure of the separating the LCD Display & Touchscreen from the frame, you can use again hot air. This will make separating more easy.
    • At the beginning you can use a cutter to make a room for the plastic tool.

    • During the procedure of the separating the LCD Display & Touchscreen from the frame, you can use again hot air. This will make separating more easy.

  8. The original adhesive tape is left on the frame, but I prefer to put new. I put it onto the original. Gently assemble the screen to the frame. Gently assemble the screen to the frame.
    • The original adhesive tape is left on the frame, but I prefer to put new. I put it onto the original.

    • Gently assemble the screen to the frame.

  9. Did you do it successfully?
Conclusion

To reassemble your device, follow these instructions in reverse order.

13 autre(s) ont terminé cette réparation.

ZFix

Membre depuis le 09/12/2013

165 803 Réputation

305 tutoriels rédigés

Équipe

Master Techs Membre de l'équipe Master Techs

Community

287 membres

813 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 3

7 derniers jours : 13

30 derniers jours : 50

Total : 36,953