HTC SMT 6175 Ear Speaker Replacement

Rédigé par : Luke Plewa (et 5 autres contributeurs)

Commentaires : 0
Favoris : 3

Difficulté

Modérée

Étapes

Temps nécessaire

5 minutes

Introduction

This guide will lead the user through the process of disassembling their smart phone in order to remove the broken speaker. In just a few short, easy to follow steps this goal can be accomplished with little knowledge and only a few basic tools.

Outils

Acheter ces outils

Pièces

Aucune pièce spécifiée.

Étape 1 Back Case

First, flip the phone over so that the back is facing you.

First, flip the phone over so that the back is facing you.

Modifier

Étape 2

Next, using both thumbs, carefully push the back side of the phone's exterior up, removing it from the main section of the phone.

Set this piece aside until you need to reassemble the phone.

Next, using both thumbs, carefully push the back side of the phone's exterior up, removing it from the main section of the phone.
Set this piece aside until you need to reassemble the phone.

Modifier

Étape 3 Battery

Insert thumb and pointer finger into the notch above the battery. Pull the battery away from the rest of the phone and set it aside.

Insert thumb and pointer finger into the notch above the battery. Pull the battery away from the rest of the phone and set it aside.

Modifier

Étape 4 Speaker

Next, choose the matching tool from your driver kit and remove the six screws found around the perimeter of the phone.

Once the screws are removed make sure to keep them in a safe place for reassembly.

Next, choose the matching tool from your driver kit and remove the six screws found around the perimeter of the phone.
Once the screws are removed make sure to keep them in a safe place for reassembly.

Modifier

Étape 5

This can be difficult. Start by slowly pulling the back part from the front shell. As it starts to lift up, continue moving around the phone until it is in two separate pieces.

Carefully pull off the back casing.
This can be difficult. Start by slowly pulling the back part from the front shell. As it starts to lift up, continue moving around the phone until it is in two separate pieces.

Modifier