Introduction

Use this guide to gain access to the motherboard of your HTC Thunderbolt. It is the main control for the entire phone.

Insert the plastic opening tool into the top of the Thunderbolt near the power button.
  • Insert the plastic opening tool into the top of the Thunderbolt near the power button.

  • Gently pry up on the rear panel around the edges until it is loose.

Ajouter un commentaire

Lift and remove the rear panel.
  • Lift and remove the rear panel.

Ajouter un commentaire

  • Using the plastic opening tool, lift up the battery from the bottom near the kickstand.

  • Remove the battery from the inner frame.

Ajouter un commentaire

  • Use your finger to push the MicroSD card in towards the top of the phone, allowing it to be released from the casing.

Ajouter un commentaire

  • Use tweezers to grab onto the MicroSD card and carefully remove it from the casing.

Ajouter un commentaire

  • Remove the six Phillips screws from the perimeter of the rear frame.

  • By removing the screw with the "void" sticker on it, your Thunderbolt will no longer be covered under warranty.

Ajouter un commentaire

  • Insert the plastic opening tool into the bottom of the phone underneath the soft keys.

  • Gently pry up on the plastic cover by sliding the plastic opening tool across the bottom of the phone.

  • Remove the plastic cover.

  • The plastic cover will have adhesive on it making it difficult to remove.

Ajouter un commentaire

  • Remove the two Phillips screws where the plastic cover was.

Ajouter un commentaire

  • Insert the plastic opening tool in between the screen and the frame on the side of the phone.

  • Slowly slide the the plastic opening tool along the side of the phone until the screen begins to separate from the frame.

  • Do the same for the opposite side of the phone.

Ajouter un commentaire

  • Carefully separate the screen and phone from the rear frame, starting from the bottom.

  • Gently pull down on the phone and screen to fully separate it from the rear frame.

Ajouter un commentaire

  • Using the tip of an plastic opening tool flip up the tab holding the capacitive button ribbon cable.

  • Be careful opening these tabs as they are very easy to break.

  • Use a pair of tweezers to pull the capacitive button cable out of its socket.

Ajouter un commentaire

  • Lifting from the side where the ribbon was disconnected, flip over the motherboard.

  • Remove the black tape covering the tabs connecting the motherboard and LCD.

Ajouter un commentaire

  • Using the plastic opening tool pop up the two tabs connecting the LCD and motherboard.

Ajouter un commentaire

  • Once the tabs have been popped up, slowly pull the two pieces away from each other.

  • If there is resistance pulling apart the phone then a ribbon or tab has not been disconnected properly/completely.

Ajouter un commentaire

  • The motherboard should now be completely disconnected

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Vanessa

Membre depuis le 18/01/2013

60 Réputation

4 tutoriels rédigés

Équipe

Cal Poly, Team 19-45, Regan Winter 2013 Membre de l'équipe Cal Poly, Team 19-45, Regan Winter 2013

CPSU-REGAN-W13S19G45

4 membres

12 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 5

Total : 1,552