Introduction

Use this guide to replace a speaker that no longer outputs sound.

Insert the plastic opening tool into the top of the Thunderbolt near the power button.
  • Insert the plastic opening tool into the top of the Thunderbolt near the power button.

  • Gently pry up on the rear panel around the edges until it is loose.

Ajouter un commentaire

Lift and remove the rear panel.
  • Lift and remove the rear panel.

Ajouter un commentaire

  • Using the plastic opening tool, lift up the battery from the bottom near the kickstand.

  • Remove the battery from the inner frame.

Ajouter un commentaire

  • Remove the six Phillips screws from the perimeter of the rear frame.

  • By removing the screw with the "void" sticker on it, your Thunderbolt will no longer be covered under warranty.

Ajouter un commentaire

  • Insert the plastic opening tool into the bottom of the phone underneath the soft keys.

  • Gently pry up on the plastic cover by sliding the plastic opening tool across the bottom of the phone.

  • Remove the plastic cover.

  • The plastic cover will have adhesive on it making it difficult to remove.

Ajouter un commentaire

  • Remove the two Phillips screws where the plastic cover was.

Ajouter un commentaire

  • Insert the plastic opening tool in between the screen and the frame on the side of the phone.

  • Slowly slide the the plastic opening tool along the side of the phone until the screen begins to separate from the frame.

  • Do the same for the opposite side of the phone.

Ajouter un commentaire

  • Carefully separate the screen and phone from the rear frame, starting from the bottom.

  • Gently pull down on the phone and screen to fully separate it from the rear frame.

Ajouter un commentaire

  • Remove the two Phillips screws securing rear inner frame to device.

Ajouter un commentaire

  • Insert the plastic opening tool between the rear inner frame and the motherboard and slowly work your way around the device.

Ajouter un commentaire

  • Remove the rear inner frame from the rest of the device.

Ajouter un commentaire

  • Flip over rear inner frame.

Ajouter un commentaire

  • Pry out speaker with plastic opening tools.

  • You have now removed the speaker.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Brandon Younger

Membre depuis le 17/01/2013

212 Réputation

8 tutoriels rédigés

Équipe

Cal Poly, Team 19-45, Regan Winter 2013 Membre de l'équipe Cal Poly, Team 19-45, Regan Winter 2013

CPSU-REGAN-W13S19G45

4 membres

12 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 515