Aller au contenu principal

Introduction

Use this guide to remove and replace the focus knob on an HTC Vive.

  1. Use tweezers to remove the small stickers over the four screws securing the outer shell. Use a T5 Torx driver to remove the four 3.4 mm-long screws securing the outer shell. Use a T5 Torx driver to remove the four 3.4 mm-long screws securing the outer shell.
    • Use tweezers to remove the small stickers over the four screws securing the outer shell.

    • Use a T5 Torx driver to remove the four 3.4 mm-long screws securing the outer shell.

  2. Use the flat end of a spudger to pry up the top edge of the right half of the outer shell, behind the component cover and near the seam in the center, until it is unclipped from the headset. Use the flat end of a spudger to pry up the top edge of the right half of the outer shell, behind the component cover and near the seam in the center, until it is unclipped from the headset.
    • Use the flat end of a spudger to pry up the top edge of the right half of the outer shell, behind the component cover and near the seam in the center, until it is unclipped from the headset.

  3. Grasp the right half the outer shell and pull it to the right and toward the front of the headset until you feel the clips on the front of the cover release. If the shell is difficult to remove, try prying along the seam with the flat end of a spudger to release the clips.
    • Grasp the right half the outer shell and pull it to the right and toward the front of the headset until you feel the clips on the front of the cover release.

    • If the shell is difficult to remove, try prying along the seam with the flat end of a spudger to release the clips.

  4. Slide the right side of the outer shell to the right and off of the headset. Slide the right side of the outer shell to the right and off of the headset.
    • Slide the right side of the outer shell to the right and off of the headset.

  5. Repeat the last three steps for the left side of the outer shell and remove it. Repeat the last three steps for the left side of the outer shell and remove it.
    • Repeat the last three steps for the left side of the outer shell and remove it.

  6. Use a PH000 driver to remove the screw securing the focus knob.
    • Use a PH000 driver to remove the screw securing the focus knob.

  7. Slide the focus knob off of the focus rod and remove it. Slide the focus knob off of the focus rod and remove it.
    • Slide the focus knob off of the focus rod and remove it.

Conclusion

Compare your new replacement part to the original part—you may need to transfer remaining components or remove adhesive backings from the new part before installing.

To reassemble your device, follow the above steps in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Check out our Answers community for troubleshooting help.

Une autre personne a terminé cette réparation.

Adam O'Camb

Membre depuis le 11/04/2015

145 880 Réputation

417 tutoriels rédigés

Équipe

iFixit Membre de l'équipe iFixit

Community

138 membres

17 020 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 6

Total : 1,004