Introduction
This guide demonstrates the procedure for replacing a faulty camera in the HTC myTouch 3G.
Ce dont vous avez besoin
-
-
Press both thumbs on each side of the upper corners, and apply pressure in a downward motion.
-
While applying downward pressure, slide the back cover down and off the phone.
-
-
-
Remove the four 6 mm T5 Torx screws from the four corners on the back of the phone.
-
Remove the two 4 mm T5 Torx screws from the middle of the back of the phone.
-
-
-
-
Insert a spudger into the gap between the frame and cover. Push downward with the spudger to separate the back plate from the phone.
-
With the spudger in the gap between the frame and cover, move the spudger around the edge of the of the phone to finish removing the back plate.
-
-
-
Remove the 3 mm Phillips screw located on the side of the bottom left-hand corner of the phone.
-
Remove the 3 mm Phillips screw located on the top right-hand corner of the phone.
-
-
-
Place a finger between the circuit board and front cover, and lift the circuit board gently.
-
Separate the circuit board from the front cover and screen to access the ribbon cable holding them together. Detach the ribbon cable.
-
Finish separating the circuit board from the front panel.
-
-
-
Turn the piece housing the circuit boards over to the side with the mounted camera.
-
Remove the three 3-mm Phillips head screws located on the top circuit board.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
Une autre personne a terminé cette réparation.
Équipe
Cal Poly, Team 2-9, Propen Fall 2012 Membre de l'équipe Cal Poly, Team 2-9, Propen Fall 2012
CPSU-PROPEN-F12S2G9
3 membres
10 tutoriels rédigés
