Aller au contenu principal

Introduction

If the LED lights do not function after troubleshooting, you might need to change the LED Board. For this replacement you need a Phillips #2 screw driver and a metal spudger.

Pièces

Aucune pièce spécifiée.

  1. Use a metal spudger to remove the top cover. Use a Phillips #2 screwdriver to remove three 17 mm screws. Use a Phillips #2 screwdriver to remove three 17 mm screws.
    • Use a metal spudger to remove the top cover.

    • Use a Phillips #2 screwdriver to remove three 17 mm screws.

  2. Fix Kits pour iPhone X

    Finie la garantie ? Pas de soucis, nous avons de quoi réparer.

    Acheter maintenant

    Fix Kits pour iPhone X

    Finie la garantie ? Pas de soucis, nous avons de quoi réparer.

    Acheter maintenant
  3. Grip larger cable connected to LED board and pull volume wheel until both are disconnected from the cable. Pull lightly on the LED board to disconnect the smaller LED board cable from volume wheel. Pull lightly on the LED board to disconnect the smaller LED board cable from volume wheel.
    • Grip larger cable connected to LED board and pull volume wheel until both are disconnected from the cable.

    • Pull lightly on the LED board to disconnect the smaller LED board cable from volume wheel.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Khalid Almutairi

Membre depuis le 02/10/2018

85 Réputation

1 tutoriel rédigé

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 3

30 derniers jours : 10

Total : 104