Aller au contenu principal

Introduction

If your Invoke is not connecting to your computer in order to be serviced, there might be a problem with the service port and should be replaced. For this replacement you will need a metal spudger and a #10 Torx screwdriver.

Pièces

Aucune pièce spécifiée.

  1. Use a metal spudger to remove the rubber bottom. Use a metal spudger to remove the rubber bottom.
    • Use a metal spudger to remove the rubber bottom.

  2. Use a #10 Torx screwdriver to remove four 14 mm screws. Use a #10 Torx screwdriver to remove four 14 mm screws.
    • Use a #10 Torx screwdriver to remove four 14 mm screws.

  3. Batteries pour ordinateurs portables

    Une réparation facile pour un gain en puissance max.

    Acheter maintenant

    Batteries pour ordinateurs portables

    Une réparation facile pour un gain en puissance max.

    Acheter maintenant
  4. Firmly grip the bottom and wiggle upwards to remove the base. Firmly grip the bottom and wiggle upwards to remove the base.
    • Firmly grip the bottom and wiggle upwards to remove the base.

  5. Use a #10 Torx screwdriver to remove two 10 mm screws from board attached to ports. Pull board up lightly. Pull board up lightly.
    • Use a #10 Torx screwdriver to remove two 10 mm screws from board attached to ports.

    • Pull board up lightly.

  6. Pull cable to disconnect board from device. For replacement of service port, you will have to replace whole board that the port is attached to.
    • Pull cable to disconnect board from device.

    • For replacement of service port, you will have to replace whole board that the port is attached to.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Angel A. Grageda

Membre depuis le 02/10/2018

635 Réputation

4 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 4

30 derniers jours : 15

Total : 146