Introduction
If you have looked at the troubleshooting page and identified that your issues with your Onyx Studio 2 are indeed due to the circuit board being bad, this guide will walk you through how to replace it.
Ce dont vous avez besoin
-
-
Using a plastic opening tool, pry off the front grill by wedging it in the notch on the front of the device.
-
-
-
Remove the five 14.4 mm T10 Torx screws.
There are NO torxscrews. You have to pull out the rubber grille grips that are inside the screw holes FIRST, then use a regular sized Phillips head screwdriver to remove the cover. No Torxscrewdiver needed. I found this out after I had already purchased one from you guys.
Mi bocina no tiene los 5 tornillos a la vista,tiene las cavidades ciegas, como lo abro???
-
-
-
-
Remove the four wires connecting the front and back panels.
-
Pinch the connector tab and pull gently upwards.
-
Repeat for the other three connectors.
-
-
-
Disconnect the remaining connectors from the circuit board.
-
Disconnect the Bluetooth antenna.
-
-
-
Remove the four 10 mm T10 Torx screws.
-
Pull the circuit board out of the device as it is now free.
Bisa di kirim
Bisa pesan 1
I own two of these and the both shut down on their own.. where do I buy the replacement boards from?
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
11 autres ont terminé cette réparation.
5 commentaires
Where do I get another one
Where we buy the board?
Umm… this was rather anticlimactic. Last step was basically like “and now contemplate your life choices”.
Where can I Buy a new hk onix studio Main board?
My speaker was working great. I just disconnected my phone to make a call, put YouTube back on it was all mumbled & the big button in the back kept pulsing so fast.
Where can I find a new front panel for my speaker
consomme69 - Réponse
If I take this off can I put it back on
Burger King - Réponse