Introduction
If you need to access the insides of your speaker, you first have to take apart the device. This guide walks you through how to take apart the front panel.
Ce dont vous avez besoin
-
-
Using a plastic opening tool, pry off the front grill by wedging it in the notch on the front of the device.
-
-
-
Remove the five 14.4 mm T10 Torx screws.
There are NO torxscrews. You have to pull out the rubber grille grips that are inside the screw holes FIRST, then use a regular sized Phillips head screwdriver to remove the cover. No Torxscrewdiver needed. I found this out after I had already purchased one from you guys.
Mi bocina no tiene los 5 tornillos a la vista,tiene las cavidades ciegas, como lo abro???
-
-
-
-
Remove the four wires connecting the front and back panels.
-
Pinch the connector tab and pull gently upwards.
-
Repeat for the other three connectors.
-
To reassemble, follow these steps in reverse order.
To reassemble, follow these steps in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
2 autres ont terminé cette réparation.
Équipe
USF Tampa, Team 16-5, Blackwell Spring 2017 Membre de l'équipe USF Tampa, Team 16-5, Blackwell Spring 2017
USFT-BLACKWELL-S17S16G5
3 membres
24 tutoriels rédigés
Un commentaire
Hi, I have the ONYX STUDIO with the silver ring that serves as the stand and the handle at the same time. After removing the front grill, I find the same five holes as it is shown on your pics but there are no screws. I can just see a bottom made of plastic. Do you have experience with that? Is that just some cover I can get thru using a screwdriver and I find the screws beneath?
I want to look inside as I am facing the problem with not working battery. As soon as I unplug the power source, it stops working.
Thank you for your comments.
Where can I find a new front panel for my speaker
consomme69 - Réponse
If I take this off can I put it back on
Burger King - Réponse