Introduction
The furby speaker is connected to a circuit board that is accessible once the outer shell is removed. Removing the connector tabs are the hardest part of this guide.
Ce dont vous avez besoin
-
-
Use a flathead screwdriver to remove the two 10mm screws on the base of the Furby.
-
-
-
-
Orient Furby to where the mouth is facing left. Locate the speaker on the side of the device.
-
Lift the speaker out.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
4 autres ont terminé cette réparation.
3 commentaires
Where can i got speaker. Please help me. Thx so much.
What are the wattage ohm and diameter of the speaker?