Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
No glue or adhesive here just insert a metal pry tool to open
-
A corner may have a good spot for this make sure that you don’t puncture the battery
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Once the back is off, we see a large battery, and a circuit board
-
There is a yellow protective covering on the board
-
Replace it during reassembly
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the screws, which can be done with the pointed tip of the pry tool, though is this is not recommended
-
And use the pry tool to get under the board
-
There is a microSD card in there, with 64GB on it
-
Upgradeability! Horray!
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
No adhesive here! HORRAY!
-
Unfortunately, there’s no plug on this battery, so while removing it from the back is easy, replacements are hard
-
We can now see the wireless charger and light array
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Overall, is was very easy to get into, with no proprietary screws, or hard to reach parts
-
The battery requires a soldering iron to replace, due to how it is permanently connected to the circuit board
-
The storage is very very easy to upgrade to a higher capacity, which is nice
-
Nothing is attached permanently to the case, which would makes swaps of parts easy, if they weren’t all soldered to the circuit board
-