Honeywell HT900C Motor Replacement

Introduction

There are a number of potential causes if your Honeywell HT900C fan does not start when you turn it on, including the fan motor being damaged from overuse, the fan being misaligned, etc. The fan motor is the most common culprit because it drives the rest of the fan. Our instructions will guide you through disassembling the old motor and installing the new one. All that is required is a screwdriver and some lubricant, both of which can be found in almost every home.

Ce dont vous avez besoin

Étape 1 Motor

Honeywell HT900C Motor Replacement, Motor: étape 1, image 1 de 3

Honeywell HT900C Motor Replacement, Motor: étape 1, image 2 de 3

Honeywell HT900C Motor Replacement, Motor: étape 1, image 3 de 3

Remove the six 15 mm screws securing the fan's frame to its outer ring on the back using a Phillips #1 screwdriver.
Due to the small size of the screw holes, a long and thin screwdriver may be necessary.

Modifier

Étape 2

Honeywell HT900C Motor Replacement: étape 2, image 3 de 3

To gain access to the fan's inner workings, gently pull the blade cover away from the main body.

Modifier

Étape 3

Remove the two 36 mm screws from the metal plate located behind the blades using a Phillips #1 screwdriver.
The screws can be hard to remove so you may need to twist the screwdriver harder and screws can be removed easily.

Modifier

Étape 4

Honeywell HT900C Motor Replacement: étape 4, image 3 de 3

Carefully pull the motor it out of its resting position and tilt it forward to access the back of the motor.

Modifier

Étape 5

Honeywell HT900C Motor Replacement: étape 5, image 3 de 3

Remove two 10 mm screws from the motor's back using a Phillips #1 screwdriver.

Modifier

Étape 6

Remove the 20 mm screws beside the fan blade using a Phillips #1 screwdriver.
The screws are attached to two parts of the motor so it can easily fall off after removing the screws.

Modifier