Introduction

The power switch allows the Hoover Power Path Pro Advanced to turn on with the press of the power button. A defective power switch will not allow the user to control the on and off state of the device and needs to be replaced.

Pièces

Aucune pièce nécessaire.

Remove the lower brushroll from the bottom of the cleaner.
  • Remove the lower brushroll from the bottom of the cleaner.

Ajouter un commentaire

Use a long #2 Philips head to remove the 8 numbered screws on the bottom of the cleaner (They will also be indicated on the bottom of the vacuum).
  • Use a long #2 Philips head to remove the 8 numbered screws on the bottom of the cleaner (They will also be indicated on the bottom of the vacuum).

Ajouter un commentaire

  • Pull the red handle to remove the front suction unit from the cleaner.

Ajouter un commentaire

  • Unscrew the hose by using a Phillips #2 to detach it from the top cover of the cleaner.

Ajouter un commentaire

  • Push down on the handle release button. Lift the edge of top cover connected to this button.

  • Repeat the above step for the "On/Off" button.

  • Pull entire top cover off.

  • Caution: when pulling the handle release button, make sure the top of the cleaner does not fall.

Ajouter un commentaire

  • Remove the "On/Off" cap by pulling it upwards with caution.

Ajouter un commentaire

  • Use a long #2 Philips head to remove the two screws from the arched grey piece.

Ajouter un commentaire

  • Pull out the red power the red power switch.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Équipe

Cal Poly, Team S16-G5, Banghart Winter 2018 Membre de l'équipe Cal Poly, Team S16-G5, Banghart Winter 2018

CPSU-BANGHART-W18S16G5

5 membres

9 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 4

7 derniers jours : 19

30 derniers jours : 61

Total : 213