Introduction

This guide is intended to help you replace the belt on your vacuum. Please see the troubleshooting guide to determine if this needs replacing. Begin by removing the brush roll.

Outils

Pièces

Aucune pièce nécessaire.

Push the red release lever to the right.
  • Push the red release lever to the right.

  • Turn the red switch counterclockwise.

  • Tilt the bottom of the plastic tray out towards you and pull it off the vacuum.

Ajouter un commentaire

Pull brush roll out of vacuum.
  • Pull brush roll out of vacuum.

  • Remove belt from brush roller

Ajouter un commentaire

  • Locate the belt to the right of where the brush roll was.

  • Remove the belt by pulling the bottom off of the pin.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Sophia Stockburger

Membre depuis le 22/01/2018

509 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team S11-G2, Banghart Winter 2018 Membre de l'équipe Cal Poly, Team S11-G2, Banghart Winter 2018

CPSU-BANGHART-W18S11G2

5 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 6

30 derniers jours : 22

Total : 84