Introduction

This guide is created to replace a damaged or broken back wheel. Tools required are a Hex Bit 4.0 tool, a bit extender, and an allen key.

Pièces

Aucune pièce nécessaire.

  1. Remove either of the two 0.2 mm axle screws by using a hex bit 4.0 by turning clockwise. The two screws are the same thread so find the screw that has the least torque. Only that screw will be able to removed in this step.
    • Remove either of the two 0.2 mm axle screws by using a hex bit 4.0 by turning clockwise.

    • The two screws are the same thread so find the screw that has the least torque. Only that screw will be able to removed in this step.

    • Turn the hex bit 4.0 counterclockwise to reassemble the axle screws.

  2. Slide off the plastic side panel. Slide off the plastic side panel. Slide off the plastic side panel.
    • Slide off the plastic side panel.

  3. %Livraison gratuite pour toute commande supérieure à 100 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique
  4. Use a hex bit 4.0 to screw back in the 0.2 mm screw as tightly as possible by turning clockwise.
    • Use a hex bit 4.0 to screw back in the 0.2 mm screw as tightly as possible by turning clockwise.

    • You will need to hold the other screw you are not replacing with an additional hex bit 4.0, so that the screws don't spin freely.

  5. Flip over the scooter and use the hex bit 4.0 to remove the other 0.2 mm screw.
    • Flip over the scooter and use the hex bit 4.0 to remove the other 0.2 mm screw.

  6. Slide off the other plastic side panel. Slide off the other plastic side panel. Slide off the other plastic side panel.
    • Slide off the other plastic side panel.

  7. On the same side you removed the screw, use the bit extender to push down on the axle inside the wheel.
    • On the same side you removed the screw, use the bit extender to push down on the axle inside the wheel.

    • The axle pops out and the wheel easily comes off.

    • Two washers will pop out with the axle.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Luke Imai

Membre depuis le 08/10/2018

133 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team S15-G5, White Fall 2018 Membre de l'équipe Cal Poly, Team S15-G5, White Fall 2018

CPSU-WHITE-F18S15G5

4 membres

5 tutoriels rédigés

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 1

Total : 39