Ce tutoriel a des changements plus récents. Passer à la dernière version non vérifiée.
Introduction
Replacing the power button of your Hover-1 H1 hoverboard can help with problems involving turning on your device.
Ce dont vous avez besoin
-
-
Remove the ten 9mm machine screws by using a long Phillips #2 screwdriver to rotate the screws counterclockwise.
-
Remove the twelve 9mm sheet metal screws by using a long Phillips #2 screwdriver to rotate the screws counterclockwise.
-
-
-
-
Unplug the power button connector by pinching the tab on the front and pulling directly upwards.
-
Pull the cable through the center section of the hoverboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
Une autre personne a terminé cette réparation.