Introduction

Here I am going to show you how to clean up solder from two points on a logic board.In this case I am working on a chinese A13 all winner tablet and I am cleaning the solder points for the battery so I can correctly install a new battery on the logic boar

The materials needed for this are a solder gun, soldering paste and desoldering wire, also known as a wick.
  • The materials needed for this are a solder gun, soldering paste and desoldering wire, also known as a wick.

Ajouter un commentaire

There are many types of soldering paste many of which are in a syringe like tube which makes it easy to get the paste in the exact spot it needs to be.
  • There are many types of soldering paste many of which are in a syringe like tube which makes it easy to get the paste in the exact spot it needs to be.

  • I personally use a plastic opening tool to scoop a little out and apply it gently on the spot I will be working on.

Ajouter un commentaire

  • The location I will be de-soldering is right above the SPK location in the photo.

Ajouter un commentaire

  • Place the de-soldering wick on the solder joint and put the tip of the solder gun on it so the wick can heat up and absorb the old solder.

  • Please remember that logic board components are very fragile and excessive heat can destroy these components.

  • Lift the wick and the solder gun up from the logic board at the same time. Failure to do so can cause the leftover solder to harden and solder the wick to the logic board and you could easily pull a logic board pad off.

Ajouter un commentaire

  • Whats left over is clean points on the solder board ready for fresh solder.

Ajouter un commentaire

Ligne d'arrivée

45 autre(s) ont terminé cette réparation.

Romin

Membre depuis le 29/04/2013

2 971 Réputation

1 tutoriel rédigé

Well Explained

Muhamamd Asif - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 3

7 derniers jours : 25

30 derniers jours : 118

Total : 5,162