Introduction

Fans on electronic devices collect a lot dust over the years, so this guide will show how to clean the fan on this Toshiba projector in order to prevent overheating. To ensure maximum performance out of a fan, some oil can be added to keep the bearings lubricated and running in tip-top shape.

Remove the two screws from the bottom plate as shown.
  • Remove the two screws from the bottom plate as shown.

Ajouter un commentaire

Remove the two screws on the bulb housing.
  • Remove the two screws on the bulb housing.

Ajouter un commentaire

  • Pull the tab up and pull the bulb out vertically. Some force will be required, but it will come out.

Change “tab” with “metal handle” or “wire handle”

lkmemphis - Réponse

  • Using a can of compressed air, blow on the fan until all dust is gone.

  • Oil can be added in with a dropper on the bearing if needed.

The bearing can be oiled with a dropper, if needed. [What kind of mechanical oil comes with a dropper? What kind of oil should be used?]

lkmemphis - Réponse

The major image for cleaning the fan should have been a bit more of a longshot so that the canned air can (or enough of it) clearly shows. Then Step 4 is fine as a close up now that the fixer knows what that red tube is connected to.

lkmemphis - Réponse

Conclusion

To reassemble your device, follow these instructions in reverse order.

Bryan Underwood

Membre depuis le 02/04/2018

697 Réputation

5 tutoriels rédigés

Équipe

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 3

Total : 37