How to Fix a Jammed Weiser SmartCode 10 Touchscreen Door Lock

Introduction

This guide will help you re-calibrate your Weiser SmartCode 10 Touchscreen Door Lock to prevent it from jamming. Calibration will help your smart lock re-learn your door and re-program itself. This will keep your lock functioning at its best and it will keep you from getting locked out of your house due to a jammed lock.

Ce dont vous avez besoin

Étape 1 How to Fix a Jammed Weiser SmartCode 10 Touchscreen Door Lock

How to Fix a Jammed Weiser SmartCode 10 Touchscreen Door Lock, How to Fix a Jammed Weiser SmartCode 10 Touchscreen Door Lock: étape 1, image 1 de 2

How to Fix a Jammed Weiser SmartCode 10 Touchscreen Door Lock, How to Fix a Jammed Weiser SmartCode 10 Touchscreen Door Lock: étape 1, image 2 de 2

Make sure the lock is in the unlock position when you start.
Use a Philips #1 screwdriver to remove the two 8 mm screws from the left and right sides of the lock.

Modifier

Étape 2

How to Fix a Jammed Weiser SmartCode 10 Touchscreen Door Lock: étape 2, image 3 de 3

Lift the faceplate from the lock.
Locate the battery pack stationed at the top of the lock and the programming button at the center of the lock.

Modifier

Étape 3

Pull the battery pack up and off to remove it from the lock housing.

Modifier

Étape 4

Re-insert the battery pack while holding down the programming button.
Ensure the battery pack is fully inserted by pushing it down.

Modifier

Étape 5

How to Fix a Jammed Weiser SmartCode 10 Touchscreen Door Lock: étape 5, image 3 de 3

Release the programming button after the indicator light turns red then green.
Repeat steps 3 through 5 if the light does not turn green.

Modifier

Étape 6

Press the program button again to allow the Smartlock to re-calibrate and reprogram itself.
The lock will lock and unlock a few times to calibrate and will remain in the lock position when the calibration is complete.

Modifier

Étape 7

How to Fix a Jammed Weiser SmartCode 10 Touchscreen Door Lock: étape 7, image 3 de 3

To reassemble your lock, reseat the faceplate on the lock.
Twist the lock switch until it aligns with the bolt mechanism and the faceplate sits flush against the lock.
Use the Phillips #1 screwdriver to secure the two 8 mm screws back into place to conclude the fix.