Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Boutique

Introduction

If your reusable face mask has a detached strap, use this guide to reattach the ripped strap.

The strap on reusable face masks is used to secure the mask onto your face, a ripped strap will cause the mask to not fully cover your mouth and nose. With the current health climate, it is important to ensure that face coverings are being used properly and effectively.

This guide includes the usage of hand sewing needles and scissors, which when handled incorrectly could cause injury to the user. There are also steps that include intricate hand work which may be difficult for those with hand joint issues.

Pièces

Aucune pièce spécifiée.

  1. Using a pair of scissors cut off any potential fraying on both the face mask and the detached strap.
    • Using a pair of scissors cut off any potential fraying on both the face mask and the detached strap.

  2. Set the face mask on a flat surface.
    • Set the face mask on a flat surface.

  3. Place the sewing thread through the hole of the hand sewing needle, this is called threading the needle. Secure the far end of the sewing thread with a knot.
    • Place the sewing thread through the hole of the hand sewing needle, this is called threading the needle.

    • Secure the far end of the sewing thread with a knot.

  4. Run the needle through the strap and the corresponding place on the face mask.
    • Run the needle through the strap and the corresponding place on the face mask.

  5. Hand stitch the strap to the mask.
    • Hand stitch the strap to the mask.

    • Repeat this until the strap is fully attached to the face mask.

  6. To end the sewing process thread the needle under the nearest stitch and pull the needle through the loop that is formed, this should create a knot.
    • To end the sewing process thread the needle under the nearest stitch and pull the needle through the loop that is formed, this should create a knot.

    • Do this twice to secure the stitches in place.

  7. Using a pair of scissors cut off any excess thread.
    • Using a pair of scissors cut off any excess thread.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Bryan Roman

Membre depuis le 23/07/2020

172 Réputation

1 tutoriel rédigé

Équipe

UW Tacoma, Team S1-G12, Cardinal Summer 2020 Membre de l'équipe UW Tacoma, Team S1-G12, Cardinal Summer 2020

UWT-CARDINAL-SU20S1G12

1 membre

1 tutoriel rédigé

Ajouter un commentaire

Afficher les statistiques:

Dernières 24 heures : 8

7 derniers jours : 50

30 derniers jours : 197

Total : 1,212