1. Gather the necessary tools
    • Gather the necessary tools

      • 1--Soldering Iron

      • 2--Solder

      • 3--DB9 Enclosure. This one is being used here.

      • 4--RS232 to TTL/CMOS converter. alldav.com sells the one used here. Cisco does not recommend or endorse Alldav specifically.

      • 5--Cable w/RJ45 connector on one end Any type of cable with an 8P8C (RJ45) connector could used as long as pins 1,2,7 & 8 are connected. A standard RJ45 cable is being used here.

      • You will also need wire strippers and possibly a screwdriver (depending on which DB9 enclosure you are using).

    Ajouter un commentaire

  2. Prep the cable. Strip the sheathing from the wires that correspond to pins 1,2,7 & 8.
    • Prep the cable. Strip the sheathing from the wires that correspond to pins 1,2,7 & 8.

    Ajouter un commentaire

    • Connect the RS232 to TTL/CMOS converter. Connect the RS232 to TTL/CMOS converter to the cable and solder the connections. Note: The colors used in the wiring diagram don't correspond to the color of the actual wires.

    Ajouter un commentaire

    • Install the Enclosure The EX90 console is now complete. The subsequent steps will cover making a console connection.

    Ajouter un commentaire

    • Make a Console Connection. Locate the Console Port. The EX90 console port is an 8P8C (RJ45) connection and is located on the bottom left corner of the unit.

    Ajouter un commentaire

    • Connect to the Console Port. Plug the 8P8C (RJ45) end into the console port. You'll have to lean the unit forward to plug the cable in. It might be a little awkward to do alone. If someone else is available, ask for their assistance. As a last resort, lay the unit down. Ensure you have something soft (like a towel) to lay the unit on.

    Ajouter un commentaire

    • Connect the DB9 to a USB serial adapter and connect to a laptop/PC.

    Ajouter un commentaire

    • Configure a Terminal Emulator Session Configure your terminal emulator with the following parameters:

      • Baud=38400

      • Data bits=8

      • Parity=none

      • Stop bits=1

      • Flow Control=none

    • The example uses HyperTerminal for Windows; configuring your terminal emulator may vary slightly.

    • You should now be at a login prompt when you connect with the terminal emulator.

    Ajouter un commentaire

Ligne d'arrivée

Une autre personne a terminé cette réparation.

eric

Membre depuis le 17/05/2012

211 Réputation

1 tutoriel rédigé

Thanks for this Amazing Blog. It is very informative and helpful for me.

<a href="http://pdfdumps.us/exam/220-801.html">Pass4sure 220-801 dumps</a>

ademarr - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 9

30 derniers jours : 42

Total : 5,466