Introduction

Use this guide to replace the front facing camera in your Huawei P10 smartphone. When reassembling your phone apply new adhesive where it is necessary.

Insert the tip of an opening pick between the back cover and the mid frame and slide it around the phone, to cut the adhesive.
  • Insert the tip of an opening pick between the back cover and the mid frame and slide it around the phone, to cut the adhesive.

Ajouter un commentaire

After you cut the adhesive on every edge, twist your opening pick, to separate the rear cover from the phone.
  • After you cut the adhesive on every edge, twist your opening pick, to separate the rear cover from the phone.

  • Flip the rear cover over to the right side of the phone.

Ajouter un commentaire

  • Use tweezers to remove the liquid indicator sticker.

Ajouter un commentaire

  • Remove the two Phillips #00 screws.

  • Remove the four 2.5 mm Phillips #00 screws.

Ajouter un commentaire

  • Use tweezers to remove the mainboard shield.

  • Use the flat end of a spudger to disconnect the finger print sensor flex cable.

    • When reassembling apply new adhesive where it is necessary.

Ajouter un commentaire

  • Remove the SIM card tray before you perform any further actions..

Ajouter un commentaire

  • Remove the three Phillips #000 screws.

  • Use tweezers to remove the two metal shields which cover the flex cables on the mainboard.

Ajouter un commentaire

  • Use the flat end of a spudger to disconnect the volume and power button, the display and the main flex cable.

Ajouter un commentaire

  • Disconnect the battery flex cable with a spudger.

  • Unplug the antenna cable with tweezers.

Ajouter un commentaire

  • Disconnect the headphone jack flex cable with the flat end of a spudger.

  • Use an opening pick to pry out the motherboard until you can get a good grip.

  • Both camera are still attached to the motherboard. Don't damage them while you remove it.

  • Remove the motherboard.

    • If you want to replace your motherboard you need to disconnect both cameras and transfer them to your spare part.

Ajouter un commentaire

  • Disconnect the flex cable of the front facing camera with a spudger.

  • Flip the motherboard and grab the front facing camera with tweezers. Thread the flex cable through the gap in the motherboard.

  • Remove the front facing camera.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order. When reassembling your phone apply new adhesive where it is necessary.

Dominik Schnabelrauch

Membre depuis le 23/11/2016

14 981 Réputation

265 tutoriels rédigés

Équipe

iFixit Membre de l'équipe iFixit

Community

109 membres

6 277 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 14

30 derniers jours : 79

Total : 363