Réparez vos affaires Communauté Boutique

Huawei P30 Pro Battery Disconnect Procedure

Conditions préalables uniquement
Ce tutoriel est uniquement destiné à être utilisé comme prérequis d'autres tutoriels. Il ne se suffit pas à lui-même.

Introduction

prereq battery disconnect

Ce dont vous avez besoin

  1. Huawei P30 Pro Battery Disconnect Procedure, Rear Glass: étape 1, image 1 de 1

    • Before you begin, switch off your phone.

    • Apply a heated iOpener to the back of the phone to loosen the adhesive beneath the back cover. Apply the iOpener for at least two minutes.

    Traduire

  2. Huawei P30 Pro Battery Disconnect Procedure: étape 2, image 1 de 3 Huawei P30 Pro Battery Disconnect Procedure: étape 2, image 2 de 3 Huawei P30 Pro Battery Disconnect Procedure: étape 2, image 3 de 3

    • Secure a suction handle to the bottom of the back cover, as close to the edge as possible.

    • If the phone's rear glass is cracked, the suction handle may not stick. Try lifting it with strong tape, or superglue the suction handle in place and allow it to cure so you can proceed.

    • Lift the back cover with the suction handle to create a small gap between the cover and the frame.

    • Insert an opening pick into the gap.

    • If you have trouble, apply more heat to further soften the adhesive. Follow the iOpener instructions to avoid overheating.

    • Slide the opening pick to the bottom right corner.

    Traduire

  3. Huawei P30 Pro Battery Disconnect Procedure: étape 3, image 1 de 2 Huawei P30 Pro Battery Disconnect Procedure: étape 3, image 2 de 2

    • Insert a second opening pick and slide it to the bottom left corner to cut the adhesive.

    • Leave the opening picks in place to prevent the adhesive from resealing.

    Traduire

  4. Huawei P30 Pro Battery Disconnect Procedure: étape 4, image 1 de 3 Huawei P30 Pro Battery Disconnect Procedure: étape 4, image 2 de 3 Huawei P30 Pro Battery Disconnect Procedure: étape 4, image 3 de 3

    • Insert a third opening pick at the bottom left corner.

    • In the next few steps whilst cutting around the rear camera make sure you only use the tip of the opening pick to avoid smearing the lens or damaging the camera.

    • Slide the tip of the opening pick from the bottom left corner along the side of the phone to cut the adhesive.

    • Leave the opening pick in its place at the top left corner to prevent the adhesive from resealing.

    Traduire

  5. Huawei P30 Pro Battery Disconnect Procedure: étape 5, image 1 de 2 Huawei P30 Pro Battery Disconnect Procedure: étape 5, image 2 de 2

    • If the adhesive becomes hard to cut, it most likely cooled down. Use your iOpener to reheat it.

    • Insert a fourth opening pick under the top left corner of the back cover.

    • Slide the opening pick along the top edge of the phone to cut the adhesive.

    • Leave the opening pick in the top right corner to prevent the adhesive from resealing.

    Traduire

  7. Huawei P30 Pro Battery Disconnect Procedure: étape 6, image 1 de 2 Huawei P30 Pro Battery Disconnect Procedure: étape 6, image 2 de 2

    • Insert a fifth opening pick at the top right corner of the phone.

    • Slide the opening pick along the right side to cut the remaining adhesive.

    Traduire

  8. Huawei P30 Pro Battery Disconnect Procedure: étape 7, image 1 de 2 Huawei P30 Pro Battery Disconnect Procedure: étape 7, image 2 de 2

    • Lift and remove the back cover.

    • Before installing fresh adhesive and reassembling, remove any remaining adhesive from the phone, and clean the glued areas with isopropyl alcohol and a lint-free cloth.

    • During reassembly, this is a good point to power on your phone and test all functions before sealing it up. Be sure to power your phone back down completely before you continue working.

    • Secure the new back cover with pre-cut adhesive or double-sided adhesive tape. After installing the rear glass, apply pressure for several minutes to help the adhesive form a good bond, such as by placing it under a stack of heavy books.

    Traduire

  9. Huawei P30 Pro Battery Disconnect Procedure, Motherboard Cover with NFC & Charging Coil: étape 8, image 1 de 1

    • Remove the ten Phillips #00 screws (4.3 mm length).

    Traduire

  10. Huawei P30 Pro Battery Disconnect Procedure: étape 9, image 1 de 2 Huawei P30 Pro Battery Disconnect Procedure: étape 9, image 2 de 2

    • Slide an opening pick under the black adhesive at the bottom right of the charging coil.

    • Carefully loosen the adhesive with the opening pick.

    Traduire

  11. Huawei P30 Pro Battery Disconnect Procedure: étape 10, image 1 de 2 Huawei P30 Pro Battery Disconnect Procedure: étape 10, image 2 de 2

    • Slide an opening pick under the black adhesive at the bottom left of the charging coil.

    • Carefully loosen the adhesive with the opening pick.

    Traduire

  12. Huawei P30 Pro Battery Disconnect Procedure: étape 11, image 1 de 2 Huawei P30 Pro Battery Disconnect Procedure: étape 11, image 2 de 2

    • Slide an opening pick under the left side of the motherboard cover.

    • Unhinge the left side of the motherboard cover by slightly rotating the opening pick.

    Traduire

  13. Huawei P30 Pro Battery Disconnect Procedure: étape 12, image 1 de 2 Huawei P30 Pro Battery Disconnect Procedure: étape 12, image 2 de 2

    • Push the motherboard cover out of the sockets at the top edge of the phone beginning with the top left corner.

    • Remove the motherboard cover including the NFC and charging coil.

    Traduire

  14. Huawei P30 Pro Battery Disconnect Procedure, Battery Disconnect: étape 13, image 1 de 2 Huawei P30 Pro Battery Disconnect Procedure, Battery Disconnect: étape 13, image 2 de 2

    • Use a spudger to pry up and disconnect the battery connector.

    • When you disconnect connectors like these, be careful not to dislodge the small surface-mounted components surrounding the socket.

    Traduire
Conclusion

To reassemble your device, follow these instructions in reverse order.

Auteur

Dominik Schnabelrauch

Membre depuis le 11/23/16

203 160 Réputation

682 tutoriels rédigés

Badges: 40

+ 37 badges supplémentaires

Équipe

iFixit Membre de l'équipe iFixit

Staff

135 membres

16 767 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 53