Introduction

Use this guide if your Huawei Union will not charge when plugged into a charger or begins losing charge faster than previously observed.

Wedge your thumb nail, or the flat end of a spudger, into the bottom left corner and pry off.
  • Wedge your thumb nail, or the flat end of a spudger, into the bottom left corner and pry off.

Ajouter un commentaire

Use the flat end of a spudger, or fingernail, to lift up the battery and pull out.
  • Use the flat end of a spudger, or fingernail, to lift up the battery and pull out.

Ajouter un commentaire

  • Remove the thirteen 3mm Phillips #00 screws from the back panel.

Ajouter un commentaire

  • Use the flat end of a spudger to pry off the back panel.

Ajouter un commentaire

  • Remove a single 3mm Phillips #00 screw from the motherboard.

Ajouter un commentaire

  • Using the flat end of a spudger to disconnect the motherboard ribbon cable.

Ajouter un commentaire

  • Firmly hold the second ribbon cable's plastic film cover and pull up to disconnect.

Ajouter un commentaire

  • Wedge the flat end of a spudger underneath the motherboard and pry upwards to separate it from the frame.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Brittany Achor

Membre depuis le 14/02/2018

651 Réputation

6 tutoriels rédigés

Équipe

USF Tampa, Team S1-G1, Nance Spring 2018 Membre de l'équipe USF Tampa, Team S1-G1, Nance Spring 2018

USFT-NANCE-S18S1G1

4 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 2

Total : 61