Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use a 4 mm Phillips screwdriver to remove the seven screws to disassemble the housing of the drill.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Open the housing of the drill.
-
Detach the electric circuit and place it next to the drill.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Cut each tubing from the three wires of the battery with a utility knife.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Disconnect the three wires of the battery with a soldering iron.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Place each new tubing (three in total) on the battery wires through sliding them on each wire.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Attach the two batteries to each other with tape, in case you have two separate batteries.
-
Use solder and a solder iron to attach the new battery to the wires.
-
Slide the tubings on each connection and heat each tubing with a lighter to make them shrink.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Place the electric circuit and the rotation switch back into the housing.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Put the housing back on the drill through clicking and closing it.
-
Put the seven screws back into the housing with the Phillips screwdriver.
-
Annulation : je n'ai pas terminé ce tutoriel.
4 autres ont terminé cette réparation.
5 commentaires
The difficult and dangerous operation is the tag connection to the Li-ion battery case. The Weller soldering iron shown in (7) has the wrong shape solder tip. The connection to a Li-ion must be made quickly and without significant heating of the Li-ion. Connections are usually spot welded but an amateur could try a solder gun.
The replacement batteries should be Li-ion size 18650 of at least 1500 mAh and identical. These are available with tags already attached and I would buy these and crimp to the tags. I have not done this myself because I found the receipt and the drill was bought 3 years ago so it is going back. The batteries were manufactured 4 years before I bought the drill so they were old when I bought it.
Anyone know where I can get new brushes for the motor? Or a motor itself? Everything else works fine on my now 12 year old drill!
Where can I buy the these battery
Kenapa bor dicasindikat