Réparez vos affaires Communauté Boutique

Insignia NS-HD01A Battery Replacement

Rédigé par : Joel Najmon (et 3 autres contributeurs)
  • Commentaires : 0
  • Favoris : 0
  • Réparations terminées : 2

Difficulté

Facile

Étapes

5

Temps nécessaire

5 minutes

Sections

1

Drapeaux

0

Introduction

This guide will show you how to remove the back cover and replace the battery in the radio. There will be several small screws and rubber covers so make sure you have a container to keep them in so that they are not lost.

  1. Remove the rubber screw caps using the pointed tip of the Spudger.

    • Remove the rubber screw caps using the pointed tip of the Spudger.

    Modifier

  2. Remove the four 6.0 mm Phillips screws located below the rubber caps using the PH00 bit installed in the driver.

    • Remove the four 6.0 mm Phillips screws located below the rubber caps using the PH00 bit installed in the driver.

    Modifier

  4. Use the plastic opening tool to pry open the back cover. Slide the tool around the sides of the radio to gradually pry the back cover off. Do not remove the cover completely as there is still a cable connecting it to radio.

    • Use the plastic opening tool to pry open the back cover.

    • Slide the tool around the sides of the radio to gradually pry the back cover off. Do not remove the cover completely as there is still a cable connecting it to radio.

    Modifier

  5. Use the blunt tweezers to unplug the battery cable from the PCB board. Grab the battery cable plug from the sides. Use the blunt tweezers to unplug the battery cable from the PCB board. Grab the battery cable plug from the sides. Use the blunt tweezers to unplug the battery cable from the PCB board. Grab the battery cable plug from the sides.

    • Use the blunt tweezers to unplug the battery cable from the PCB board. Grab the battery cable plug from the sides.

    Modifier

  6. Use the flat side of the Spudger to pry the battery out of the back cover. Insert the replacement battery into the back cover.

    • Use the flat side of the Spudger to pry the battery out of the back cover.

    • Insert the replacement battery into the back cover.

    • Reassemble the radio, making sure to reconnect the battery cable.

    Modifier
Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autres ont terminé cette réparation.

Auteur

avec 3 autres contributeurs

Joel Najmon

Membre depuis le 08/10/2016

152 Réputation

1 tutoriel rédigé

Badges: 4

+ 1 badge de plus

Équipe

IUPUI, Team 2-2, Wilson Fall 2016 Membre de l'équipe IUPUI, Team 2-2, Wilson Fall 2016

IUPUI-WILSON-F16S2G2

5 membres

1 tutoriel rédigé

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 5

30 derniers jours : 15

Total : 707