1. Turn the phone over to where the battery compartment resides.
    • Turn the phone over to where the battery compartment resides.

    • Remove the battery compartment door by pushing down on the door with your thumbs and sliding the door off of the bottom of the device.

    • Remove battery.

    Ajouter un commentaire

  2. Use a Phillips #0 screwdriver  to remove the screw in the middle of the battery compartment.
    • Use a Phillips #0 screwdriver to remove the screw in the middle of the battery compartment.

    • Pry open the case body with the plastic opening tool. Start at the bottom of the device and work toward the top. You will hear a "click" sound as the sides open.

    Ajouter un commentaire

    • There is a wire connector linking the front and the back of the device.

    • Carefully pull the wire connectors out of the white connector gauge to completely separate the front and back pieces.

    Ajouter un commentaire

  3. Répandez la magie de Noël
    Obtenez 12 $ de réduction sur les commandes de 50 $ ou plus avec le code FIXMAS12
    Répandez la magie de Noël
    Obtenez 12 $ de réduction sur les commandes de 50 $ ou plus avec le code FIXMAS12
    • The power button may fall off when you separate the front and back of the device. This can simply be placed back when reassembling.

    • Find the lever on the right side of the back half of the device.

    • Insert the tip of the lever into the square indent on the underside of the button.

    Ajouter un commentaire

    • Avoid picking up the front of the device as you work so that loose parts will not shift.

    • Use a Philips #0 head screwdriver to remove two screws; one on either side of the circuit board.

    Ajouter un commentaire

    • Slide the circuit board down from the tab located underneath the top of the back half

    • The laser is attached to the circuit board and will slide out of its own housing as you slide out the circuit board.

      • Use tweezers to gently remove it if it doesn't come out .

    Ajouter un commentaire

    • Use desoldering braid to remove the red and black wires attached to both the circuit board and the laser bulb.

    • When you are ready to attach the new laser bulb, use a soldering iron to solder the new bulb's wires to the circuit board.

    Ajouter un commentaire

Ligne d'arrivée

Alayna Bruney

Membre depuis le 11/02/2014

1 Réputation

1 tutoriel rédigé

Équipe

Ohio State, Team 1-1, Buehl Spring 2014 Membre de l'équipe Ohio State, Team 1-1, Buehl Spring 2014

OSU-BUEHL-S14S1G1

4 membres

3 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 112