Annuler

Iomega Z100S2 Case Replacement

Rédigé par : Chris Rudolph (et 3 autres contributeurs)

Commentaires : 0
Favoris : 3
Réparations terminées : 2

Iomega Z100S2 Case Replacement

Difficulté

Facile

Étapes

5

Temps nécessaire

2 - 5 minutes

Outils

Acheter ces outils

Spudger

3,99 $US

Acheter

Pièces

Aucune pièce spécifiée.

Étape 1 Case

Push in the plastic tab that can be seen through cracks in the front left corner using a spudger.

Push in the plastic tab that can be seen through cracks in the front left corner using a spudger.

Push in the plastic tab that can be seen through cracks in the front left corner using a spudger.

Étape 2

Move down the same side and push in the plastic tab.

Move down the same side and push in the plastic tab.

Étape 3

Move to the front right side and once again push in the plastic tab.

Move to the front right side and once again push in the plastic tab.
There is not a fourth tab to push in after this one.

Étape 4

Grab the cover by the front side and pull upwards.

You might encounter some resistance. Pull firmly, but don't yank it.

Grab the cover by the front side and pull upwards.
You might encounter some resistance. Pull firmly, but don't yank it.

Étape 5

Tilt the front case down until the pegs detach from the bottom of the case.

Lift up and outward.

Tilt the front case down until the pegs detach from the bottom of the case.
Lift up and outward.
The motherboard will be loose at this point.

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Auteur

avec 3 autres contributeurs

Chris Rudolph

Membre depuis le 05/10/2010

55 Réputation

1 tutoriel rédigé

+ 3 badges supplémentaires

Équipe

Cal Poly, Team 7-53, Amido Fall 2010 Membre de l'équipe Cal Poly, Team 7-53, Amido Fall 2010

CPSU-AMIDO-F10S7G53

4 membres

3 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 8

30 derniers jours : 21

Total : 3,169