JBL Everest Elite 300 Headband Cushion Replacement

Introduction

If the headband of your headphones displays signs of wear and tear or provides discomfort, then this guide is perfect for you. This guide will help you easily remove and replace the headband. All you need is a Phillips #000 screwdriver, an iFixit opening pick, and a SIM card ejector.

Ce dont vous avez besoin

Étape 1 Headband Cushion

JBL Everest Elite 300 Headband Cushion Replacement, Headband Cushion: étape 1, image 1 de 1

Extend the headphone.

Modifier

Étape 2

JBL Everest Elite 300 Headband Cushion Replacement: étape 2, image 3 de 3

Bend the hinge slightly, then remove the two .5 mm screws with a Phillips #000 screwdriver.
This will be repeated on both sides.

Modifier

Étape 3

Slide down the "Elite 300" tab.
Repeat on both sides.

Modifier

Étape 4

Use a SIM tool to push pin fully through and out.
Repeat on the other side.

Modifier

Étape 5

Go along the edges with the pick, and pull up, taking off the band.

Modifier

Étape 6

JBL Everest Elite 300 Headband Cushion Replacement: étape 6, image 3 de 3

After fully taking off the band, you are now ready to insert in the new band.
When placing in the new headband, line up the holes as shown in image 2.
The headband is difficult to replace, however after lining up the holes, the headband will snap into place. Push into the plastic and push away from you. A click will happen indicating it attatching.