JBL Pulse 2 Battery Replacement

Ce tutoriel a des changements plus récents. Passer à la dernière version non vérifiée.

Introduction

If your JBL 2 speaker isn't working correctly or delivering the high-quality sounds you expect, you may need to replace the battery. Replacing the battery can breathe new life into your device.

Ce dont vous avez besoin

Étape 1 Battery

JBL Pulse 2 Battery Replacement, Battery: étape 1, image 1 de 2

JBL Pulse 2 Battery Replacement, Battery: étape 1, image 2 de 2

Remove the rubber rings from either end of the device.
If there is difficulty in lifting the rings from the device, use the metal spudger.

Traduire

Étape 2

Remove the four 4.8mm Phillips #1 screws from each end of the device with the Phillips head screwdriver.
Lift the end pieces off of the device.

Traduire

Étape 3

Remove the four 9.5mm Phillips #1 screws from each end of the device.

Traduire

Étape 4

Peel one end off and slowly draw it across the length of the device until you get to the other side.

Traduire

Étape 5

JBL Pulse 2 Battery Replacement: étape 5, image 3 de 3

Remove the four 7.9mm Phillips #1 screws along the black centerpiece of the device between the camera and the auxiliary port.
Lift up the casing and circuit board but do not try and remove the ribbon wires.

Traduire

Étape 6

Remove the cover from the end that the ribbon wires are attached to. It should peel off easily.

Traduire

Étape 7

Unlatch the mechanism holding the ribbon wires in place, then disconnect them from the motherboard.
To access the wires, remove some of the black glue holding them in place with the spudger.

Traduire