Aller au contenu principal

JBL Pulse 2 Button Circuit Board Replacement

Ce dont vous avez besoin

  1. JBL Pulse 2 Button Circuit Board Replacement, Button Circuit Board: étape 1, image 1 de 2 JBL Pulse 2 Button Circuit Board Replacement, Button Circuit Board: étape 1, image 2 de 2
    • Remove the rubber rings from either end of the device.

    • If there is difficulty in lifting the rings from the device, use the metal spudger.

  2. JBL Pulse 2 Button Circuit Board Replacement: étape 2, image 1 de 1
    • Remove the four 4.8mm Phillips #1 screws from each end of the device with the Phillips head screwdriver.

    • Lift the end pieces off of the device.

  3. JBL Pulse 2 Button Circuit Board Replacement: étape 3, image 1 de 1
    • Remove the four 9.5mm Phillips #1 screws from each end of the device.

  4. JBL Pulse 2 Button Circuit Board Replacement: étape 4, image 1 de 2 JBL Pulse 2 Button Circuit Board Replacement: étape 4, image 2 de 2
    • Peel one end off and slowly draw it across the length of the device until you get to the other side.

  5. JBL Pulse 2 Button Circuit Board Replacement: étape 5, image 1 de 3 JBL Pulse 2 Button Circuit Board Replacement: étape 5, image 2 de 3 JBL Pulse 2 Button Circuit Board Replacement: étape 5, image 3 de 3
    • Remove the four 7.9mm Phillips #1 screws along the black centerpiece of the device between the camera and the auxiliary port.

    • Lift up the casing and circuit board but do not try and remove the ribbon wires.

  6. JBL Pulse 2 Button Circuit Board Replacement: étape 6, image 1 de 1
    • Remove the cover from the end that the ribbon wires are attached to. It should peel off easily.

  7. JBL Pulse 2 Button Circuit Board Replacement: étape 7, image 1 de 2 JBL Pulse 2 Button Circuit Board Replacement: étape 7, image 2 de 2
    • Unlatch the mechanism holding the ribbon wires in place then disconnect them from the motherboard.

    • To access the wires, remove some of the black glue holding them in place with the spudger.

  8. JBL Pulse 2 Button Circuit Board Replacement: étape 8, image 1 de 2 JBL Pulse 2 Button Circuit Board Replacement: étape 8, image 2 de 2
    • Slowly pull the ribbon wires out from the outside.

    • If there is too much resistance, remove more of the black glue.

Conclusion

To reassemble your device, follow these instructions in reverse order.

3 autres ont terminé cette réparation.

Dalton Little

Membre depuis le 08/31/18

254 Réputation

1 tutoriel rédigé

Équipe

3 commentaires

where can I buy that part

Wilco Peters - Réponse

I love you guys

Davi Dodo - Réponse

I need to buy parts

hernzum - Réponse

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 10

Total : 1,077