Aller au contenu principal

Introduction

In this guide, you will replace the LCD screen. This is necessary if the screen is faulty and does not display information properly.

Pièces

Aucune pièce spécifiée.

  1. Open the K-Cup Chamber Housing Lid by lifting up the silver handle below the LCD screen.
    • Open the K-Cup Chamber Housing Lid by lifting up the silver handle below the LCD screen.

    • This is the part of the brewer you open to place a K-Cup inside.

  2. Place the Keurig on its side. Remove the two 140mm screws located on the underside of the Chamber Lid using the Phillips #1 screwdriver.
    • Place the Keurig on its side.

    • Remove the two 140mm screws located on the underside of the Chamber Lid using the Phillips #1 screwdriver.

    • Remove the top black housing that surrounds the screen.

  3. Using the Phillips #1 screwdriver, remove the two 140mm screws connecting the silver handle to the top of the Keurig.
    • Using the Phillips #1 screwdriver, remove the two 140mm screws connecting the silver handle to the top of the Keurig.

  4. Fix Kits pour Android

    Remplacer l'écran ou la batterie est à portée de kit !

    Acheter maintenant

    Fix Kits pour Android

    Remplacer l'écran ou la batterie est à portée de kit !

    Acheter maintenant
  5. Pull out the front silver handle from the top of the brewer.
    • Pull out the front silver handle from the top of the brewer.

    • This will further expose the LCD screen.

  6. Using the metal spudger, pry off the snaps holding the LCD screen panel to the brewer.
    • Using the metal spudger, pry off the snaps holding the LCD screen panel to the brewer.

    • Warning: These snaps are very delicate and can easily be broken. Practice caution as you perform this step.

  7. Remove the top black housing by lifting it up.
    • Remove the top black housing by lifting it up.

    • This will expose the frame of the Keurig connecting to the LCD screen.

  8. Remove the black latch with the black wire connecting the front end of the panel to the frame.
    • Remove the black latch with the black wire connecting the front end of the panel to the frame.

    • The front end of the panel will now be free.

  9. On the bottom of the panel, remove the white tab that connects the wires of the circuit board to the LCD screen
    • On the bottom of the panel, remove the white tab that connects the wires of the circuit board to the LCD screen

    • To remove the tab, squeeze in on the sides of it as you pull it out.

    • Remove the touch screen panel from your device.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Alec Jamosmos

Membre depuis le 22/04/2018

764 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team S24-G8, Maness Spring 2018 Membre de l'équipe Cal Poly, Team S24-G8, Maness Spring 2018

CPSU-MANESS-S18S24G8

4 membres

5 tutoriels rédigés

Hello Alec,

Thank you for providing this repair guide! Could you kindly provide the screen size and where one might be able to purchase one? It would be greatly appreciated.

Regards.

Christopher Rodriguez - Réponse

Yes love the demo, now where would one find the screen to replace. Keurig states these are no longer available.

staci werkmeister - Réponse

Ajouter un commentaire

Afficher les statistiques:

Dernières 24 heures : 17

7 derniers jours : 122

30 derniers jours : 471

Total : 4,353