Introduction
This guide will show an individual how to replace the water filter in the Keurig K40. This will require access to a screwdriver.
Ce dont vous avez besoin
-
-
-
Flip the device on its side so that the metal faces you.
-
Begin by unscrewing the five 1.5mm bottom screws with a #0 phillips head screwdriver.
Demander à FixBot
-
-
-
Once the base is unscrewed, remove the base from the plastic wedges used to hold it in place.
-
-
-
-
Using a size 0 Philips head screwdriver, remove two 1.2mm screws that hold the filter in place.
-
Pull the pump back to remove it from the slot it was in.
-
-
-
Grip where the filter and the flow line connect and pull apart until they are separated.
-
Clean or obtain a new filter and put back together. This is done by repeating the steps in reverse, putting the device back together.
-
-
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
14 autres ont terminé cette réparation.
Équipe
USF Tampa, Team 6-1, Eyestone Spring 2016 Membre de l'équipe USF Tampa, Team 6-1, Eyestone Spring 2016
USFT-EYESTONE-S16S6G1
3 membres
15 tutoriels rédigés
13 commentaires de tutoriel
Where do you obtain a new filter?
[|i have the same question as well.. I don’t see anywhere selling a new filter…]
I need the filter, where do I buy a new Filter?
