Remove both 8.0 mm Phillips #1 screws, one for each wheel.
  • Remove both 8.0 mm Phillips #1 screws, one for each wheel.

Ajouter un commentaire

Remove the wheels by pulling them away from the RC car.
  • Remove the wheels by pulling them away from the RC car.

Ajouter un commentaire

  • Make note of where each driving gear cover is placed. They only go in one way.

  • Remove the eight 8.0mm Phillips #00 screws, two screws for each wheel.

Ajouter un commentaire

  • Pry open the two gear covers on both sides.

Ajouter un commentaire

  • Pull the driving gears off the axles by sliding them off the axles and exposing both axles.

Ajouter un commentaire

  • Slide both axles from the internal axles guides within the car.

  • Reverse the steps to replace the axles.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Rusbell Gonzalez

Membre depuis le 17/09/2014

219 Réputation

5 tutoriels rédigés

Équipe

USF Tampa, Team 1-2, Hickman Fall 2014 Membre de l'équipe USF Tampa, Team 1-2, Hickman Fall 2014

USFT-HICKMAN-F14S1G2

3 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 125