Introduction

The circuit board is a small part inside the back of the mixer. It is fairly easy to get to and doesn't require many steps.

Using a Phillips #2 screwdriver, remove the 10mm screw on the back cover by rotating it counterclockwise.
  • Using a Phillips #2 screwdriver, remove the 10mm screw on the back cover by rotating it counterclockwise.

  • The back cover is now free. Remove it by pulling it back and up.

Ajouter un commentaire

Using a Phillips #1 screwdriver, remove the 9.5mm screw above the circuit board by rotating it counterclockwise.
  • Using a Phillips #1 screwdriver, remove the 9.5mm screw above the circuit board by rotating it counterclockwise.

  • If you can't see the screw, try pulling the seal down past the wires to make the screw more accessible.

Ajouter un commentaire

  • Using pliers or tweezers, remove the connectors of the four wires attached to the circuit board.

Ajouter un commentaire

  • Grab the wires and tilt the edge of the board up to lift the circuit board up and out.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Luke Leonard

Membre depuis le 24/01/2018

349 Réputation

4 tutoriels rédigés

Équipe

Cal Poly, Team S2-G5, Livingston Winter 2018 Membre de l'équipe Cal Poly, Team S2-G5, Livingston Winter 2018

CPSU-LIVINGSTON-W18S2G5

4 membres

10 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 15

Total : 123