Aller au contenu principal

Introduction

This guide shows how to remove/replace the rear cover on a Kobo Glo HD.

This guide applies to the Kobo Glo HD (model N437), but may also apply to the Kobo Touch 2.0 (model N587).

This guide does not apply to the regular Kobo Glo and Touch models.

Pièces

Aucune pièce spécifiée.

  1. If you haven't done so already, power off your eReader by holding down the power button for 3 seconds until the display refreshes to indicate that it has powered off. Opening picks are required for this step as opening tools can be too wide to get into the gap between the rear cover and the side/front. Start by inserting the pick into the area around the power button or Micro USB port.
    • If you haven't done so already, power off your eReader by holding down the power button for 3 seconds until the display refreshes to indicate that it has powered off.

    • Opening picks are required for this step as opening tools can be too wide to get into the gap between the rear cover and the side/front.

    • Start by inserting the pick into the area around the power button or Micro USB port.

    • Don't insert it too far, as that could result in damage to the power button, status indicator, and/or Micro USB port.

    • Then, slide the pick around to undo these clips.

  2. The rear cover should then pop off. The rear cover should then pop off. The rear cover should then pop off.
    • The rear cover should then pop off.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Kevin Bhasi

Membre depuis le 26/12/2014

1 067 Réputation

9 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 1

7 derniers jours : 2

30 derniers jours : 15

Total : 277