Introduction

The button pad lets the user control actions on the LCD screen. The arrow pad allows the user to move up, down, left, right, and select.

Pièces

Aucune pièce nécessaire.

Slide the door on the bottom of the camera in the direction of the open symbol with your finger.
  • Slide the door on the bottom of the camera in the direction of the open symbol with your finger.

  • Release and the door will pop open.

Ajouter un commentaire

Slide the battery out.
  • Slide the battery out.

Ajouter un commentaire

  • Remove lens cover from the camera by squeezing the protruding button on each side of the cover and pulling.

Ajouter un commentaire

  • Pull the lens cover string toward the ground so that the loop underneath the metal slab is on top of the cover string.

  • Push up so that the string starts to come out of the top of the loop.

  • Grab the string from above the loop and pull.

Ajouter un commentaire

  • Feed the string on top into the metal slab while pulling the loop toward you until the plastic piece stops you from pulling any further.

Ajouter un commentaire

  • Separate the two pieces of the loop and pull the lens cover up in between them.

Ajouter un commentaire

  • Pull the lens cover and the sting will come out of the metal slab.

Ajouter un commentaire

  • Flip open the door on the right side of the camera, when looking at the LCD screen.

  • This door has a memory card and A/V OUT symbol on it.

Ajouter un commentaire

  • Gently push SD/MMC to eject.

Ajouter un commentaire

  • Pull SD/MMC out of the camera.

Ajouter un commentaire

  • Place lens cover back on the lens to prevent scratches or debris but leave string detached.

  • Remove a total of six 3.968mm Phillips #00 screws. Two each from the left side, bottom, and right side.

Ajouter un commentaire

  • Pull the back cover away from the front cover.

  • You may need to use a plastic opening tool as a wedge if it does not come apart by easily.

Ajouter un commentaire

  • Separate the back cover from the front cover.

Ajouter un commentaire

  • Remove two Phillips #00 screws from the inside of the button pad on the back cover.

Ajouter un commentaire

  • Remove the metal piece shown.

Ajouter un commentaire

  • Remove the black ring from the back and the white button pad will fall out from the front.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Kirsten Price

Membre depuis le 17/09/2014

343 Réputation

6 tutoriels rédigés

Équipe

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 303